网站关键词:
当前所在位置:首页>>常见问题铜门氧化的修补方法有哪些?常见问题

铜门氧化的修补方法有哪些?

来源:http://www.jnqianfu.com 日期:2020-11-24 发布人:admin浏览次数:0
铜门看起来很是大方,是身份与权力的象征。对很多人对于铜门这个并不是很了解,觉得铜门生锈氧化,是一件不可思议的事情,甚怀疑自己购买的是假铜门。其实铜门生锈很正常,生出来的是铜锈。如果我们的铜门被划伤,铜接触到空气之后,就会产生铜绿。其实无论是怎么生的锈,都会影响到铜门的外观。那么济南铜门应该如何除锈呢?
The bronze gate looks very noble and generous, which is a symbol of identity and power. For many people, they don't know much about copper doors. They think it's incredible that they rust and oxidize. They even suspect that they bought fake copper doors. In fact, it's normal for copper doors to rust. What comes out is copper rust. If our copper door is scratched, copper will produce copper green when it comes into contact with the air. In fact, no matter how rusty it is, it will affect the appearance of the copper door. So how should Jinan copper door rust removal?
济南铜门
Jinan Tongmen
一、浸泡除锈
1、 Rust removal by soaking
铜生锈的时间较长时,里面往往会包含一层土锈,这种土锈用常规的方法是很难洗掉的。此时,可以用一块湿毛巾浸泡在100度左右的开水中,然后用毛巾敷在生锈的铜门上,再用细软的小刷子刷洗即可。注意,此过程较好带隔热手套,防止手被开水烫伤,如果一次洗不掉铜锈,那反复浸泡几次即可。
When copper rusts for a long time, it often contains a layer of soil rust, which is difficult to remove by conventional methods. At this point, you can use a wet towel soaked in 100 degrees of boiling water, and then use a towel to apply on the rusty copper door, and then brush with a small soft brush. Note: this process is better to wear heat-insulating gloves to prevent hands from being scalded by boiling water. If the copper rust can not be removed at one time, it can be soaked several times.
二、干刷除锈
2、 Dry brush rust removal
铜门虽然抗腐蚀性较好,但如果长期不进行铜门保养的话,几年下来,还是会有一层浅浅的铜锈的。遇到此种较浅的铜锈时,可以用一支大号的毛笔或者细软的油漆刷来干刷除锈。刷洗的过程用力要均匀,刷完后用清水洗净,再用毛巾擦干即可。
Although the copper door has good corrosion resistance, if it is not maintained for a long time, there will still be a layer of shallow copper rust in a few years. In case of such shallow copper rust, a large brush or a soft paint brush can be used to dry brush the rust. The process of brushing should be uniform. After brushing, wash it with water and then dry it with towel.
三、刀刮除锈
3、 Remove rust by knife scraping
如果铜锈较顽固,用毛刷无法刷掉,那就可以用小刀来刮掉铜锈。但此法难度较大,稍有不慎,很容易刮伤铜门表皮。所以,如果对自己没有的信心,请不要试用。方法也很简单,把毛刷换成小刀对准铜锈轻轻的刮即可,速度一定要慢,用力轻柔并循序渐进。

济南铜门
If the rust is stubborn and cannot be removed with a brush, it can be scraped off with a knife. But this method is more difficult, a little careless, it is easy to scratch the surface of the copper door. So, if you don't have confidence in yourself, don't try it. The method is also very simple. Replace the brush with a knife and gently scrape the copper rust. The speed must be slow, gentle and gradual.
四、醋泡除锈
4、 Rust removal with vinegar bubble
如果铜门上的铜锈痕迹较深,那可用醋泡法来除锈。铜绿是碱性的,通过酸性的醋进行中和反应之后,就能很好的去除铜绿。取一个小碗,倒入半碗食醋,再用清水将铜门的生锈部位洗净,然后用毛巾蘸取食醋后敷在铜锈上。待到20小时后,用毛刷刷去掉下的残锈,再用清水洗净铜门生锈部位后擦干即可。
If the copper door on the deep traces of rust, it can be used to remove rust vinegar bubble. Copper green is alkaline, after neutralization reaction with acid vinegar, it can be removed very well. Take a small bowl, pour in half a bowl of vinegar, and then clean the rusty part of the copper door with water, and then dip the vinegar with a towel and apply it on the copper rust. After 20 hours, remove the residual rust with a brush, and then clean the rusty part of the copper door with clean water and then dry it.
济南铜门
Jinan Tongmen
如果以上方法都不能除掉您铜门上的顽固铜锈,那就只能请铜门厂帮忙了。只有叫铜门厂拆下铜门后回厂重新喷漆,方能让铜门恢复光彩,此法也无需太多钱。所以,平常对铜门稍加保养还是很有必要的,少可以大大延长铜门的寿命和美观性。
If none of the above methods can remove the stubborn rust on your copper door, you can only ask the copper door factory for help. Only ask the copper door factory to take down the copper door, and then return to the factory to spray paint again, can restore the luster of the copper door, this method also does not need too much money. Therefore, it is necessary to maintain the copper door a little, at least it can greatly extend the service life and beauty of the copper door.

新闻资讯
-News and information-
在线客服
二维码

扫描二维码